Option 1:

Using a Flexible Measuring Tape

With your palm open and facing upward, wrap the measuring tape around your wrist just above the wrist bone. Take note of the measurement to determine your wrist size.

Option 2:

Using a String or Paper Strip

With your palm open and facing upward, wrap the string or strip of paper around your wrist just above the wrist bone. Mark the point where the ends meet using a pen or marker. Next, lay the string or paper flat and measure the length up to the marked point using a ruler. This measurement is your wrist size.

Option 1:

Measure the Full Length

Lay the necklace flat on a straight surface. Measure from one end of the clasp to the other, then note the total length.

Option 2:

Measure the Necklace While Closed

Fasten the clasp and lay the necklace flat on a surface. Measure the necklace from end to end, then double the measurement to determine the full length. Record the final measurement for reference.

Option 1:

Use a Flexible Tape Measure

Place the flexible tape measure around your neck as you would wear a necklace. Adjust it to your preferred length, then note the measurement.

Option 2:

Use a String

Place a piece of string around your neck like a necklace and adjust it to your desired length. Mark the point where the ends meet using a pen or marker. Next, lay the string flat and measure its length with a ruler, then note the measurement for reference.

Option 1:

Use a Flexible Tape Measure

Wrap a flexible tape measure comfortably around your neck to determine your neck size. Next, add approximately 2 inches (5 cm) for a close fit, or up to 4 inches (10 cm) for a looser fit, to find your ideal choker length.

Option 2:

Use a String

Wrap a piece of string around the circumference of your neck and mark the point where the ends meet. Lay the string flat and measure the length to determine your neck size. Then, add 2–4 inches (5–10 cm), depending on your preferred fit, to find your perfect choker size.

Step 1:

Select a ring that fits the intended finger comfortably.

Step 2:

Place the ring on top of a ruler and measure the widest distance across the inside of the ring, from inner edge to inner edge. Lay ring on top of ruler, and measure the widest area inside the ring from inner edge to inner edge. Round to the closest whole millimetre.

Tip for Non-Circular Rings:

If your ring is not perfectly circular, measure the shortest distance across the inside of the ring.

Step 1:

Cut a long strip of paper approximately 5.0 mm wide.

Step 2:

Wrap the paper strip around the base of the finger you would like to measure. For the most accurate result, pull the paper snugly around your finger. Ring sizes are based on a close measurement, although the finished ring itself will fit more comfortably.

Step 3:

Ensure the paper overlaps evenly and remains tight, then mark the point where the paper strip meets itself.

Step 4:

Lay the paper strip flat and measure the marked length in millimetres using a ruler. Round your measurement to the nearest whole millimetre.